Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Anyone used furnace air for Kiln Drying?

Posts

Anyone used furnace air for Kiln Drying?

#1

Anyone used furnace air for Kiln Drying?

Jack Savona

A turning buddy asked if he could use the hot air from his garage furnace to kiln dry his wood (short boards, bowls, etc.). The air comes out of the rectangular wall vent below the ceiling directly into his shop. He wondered about using some venting to extend the air flow and allow a space for small boards of wood be stacked or bowls to sit. He's a McGyver, so I know he can rig it up, but will it work (in the winter of course)? Anyone tried it? Any conceptual thoughts?

Thanks in advance.

Re: Anyone used furnace air for Kiln Drying?

#2

Re: Anyone used furnace air for Kiln Drying?

John Jordan

Only if you want them cracked beyond use. A kiln is much more than a heater, which will dry the outside before the inside, so the wood HAS to crack. A kiln works to maintain an even moisture loss throughout the board.

John

Re: Anyone used furnace air for Kiln Drying?

#3

Re: Anyone used furnace air for Kiln Drying?

Brent English

Agree 100% with Mr. Jordan, that hot air going across the wood will quickly dry the outside, leaving the inside still wet. The different shrinkage between the wet wood and dry wood will cause stress leading to cracks. In internet terms: "Epic Fail"

Re: Anyone used furnace air for Kiln Drying?

#4

Re: Anyone used furnace air for Kiln Drying?

Josh bowman

Do a little research here as John said drying wood is a bit of an art. I think they run steam in and take the moisture up then slowly over days bring the moisture down.

Re: Anyone used furnace air for Kiln Drying?

#5

Re: Anyone used furnace air for Kiln Drying?

John Jordan

If you really need to dry it, (I don't) a dehumidifier kiln is basically foolproof and cheap, assuming you are drying lots of bowls or board. If you just want a few blanks dry. wax the ends and put them on the floor, later, you can move them into a place with air circulation.

If you are trying to dry one piece quickly just so you can get back to it, that's not a very good way to work, IMO.

Next time you have some green wood, stick a chunk in the heat vent. :D

John

Re: Anyone used furnace air for Kiln Drying?

#6

Thanks to all for your input.


Re: Anyone used furnace air for Kiln Drying?

#7

Vacuum drying

Jim Santerre

I am the one Jack is talking about. I like to try different things. From the responses it appears that using the furnace is out. I have had much success with vacuum stabilizing wood. What about vacuum drying? Any experience with that?