Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

DeWalt 788 Vibration

Posts

DeWalt 788 Vibration

#1

Allan W

DeWalt 788 Vibration

Allan W

This week I went to use my DeWalt 788 Scrollsaw and it was very noisy and vibrated a lot. After some research I found an article about the screws loosening on this model saw. I eventually found one of the internal screws on the rear of the saw that holds the arms on the pivots was loose. Tightened it up and it was as good as new.

Re: DeWalt 788 Vibration

#2

Re: DeWalt 788 Vibration

Darryl

Isn't there a bearing at that point where the eccentric is located? there is a you tube video on replacing/lubricating those bearings I remember seeing.

Re: DeWalt 788 Vibration

#3

Rob Wallace

Re: DeWalt 788 Vibration

Rob Wallace

You might want to post this to the regular WC messageboard - not a lot of turners using scroll saws - they tend to get in the way of the lathe!

Rob

Re: DeWalt 788 Vibration

#4

Re: DeWalt 788 Vibration

John Lucas

I use my Dewalt 788 all the time. So far it's working perfectly and haven't had to replace anything.