Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Egg production Finally over

Posts

Egg production Finally over

#1

Dan Jechura

Egg production Finally over

Dan Jechura

It started out a couple eggs, then it was 2 dozen, now it was 5 dozen. Here are some of the egss I turned for easter. I found out I should only turn 1 egg at a time. I would hold the block in a 4 jaw chuck. I would turn the the large end 1st. Then neck down the block on the small end. I then turned the small end. I would leave the egg attached to the waste block so it was easier to finish. If there was a stub of wood left I would turn a top. Still working on learning how to finish the ends.

I used oak, black walnut. apple, maple, ambrosia maple, cherry and mulberry.

comments welcome

Dan J.

Time to go back to turning bowls







Re: Egg production Finally over

#2

Steven Antonucci

On top tops

steven antonucci

If you have a standard 50mm jaw in your chuck, simply hold the top in the jaws very lightly and make sure the spindle runs true. Or, if you want to cheat a little, you can disguise a 50mm hold on the bottom of the top by making it a small bead, and then it will run true just by gripping the bead.

Light cuts and a little sanding...

S

Re: Egg production Finally over

#3

Dan Jechura

Re: On top tops

Dan Jechura

did not think of that. I was trying to figure out a way to turn the handle side.

Re: Egg production Finally over

#4

EGG-cellent!