Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

cleaning up torn grain under threaded lid

Posts

cleaning up torn grain under threaded lid

#1

cleaning up torn grain under threaded lid

John Lucas

I use a homemade scraper to make a recess under the threads on lidded boxes. I was never really satisfied with this because of the scraping action the area isn't as clean as the rest of the inside of the box lid and is almost impossible to sand.

I have a set of Hunter ornament hollowing tools. I had turned the inside of the box lid with the straight tool and left a very good finish all but that last little recess done with the scraper. I pulled out what he calls the shoulder tool and was able to get a very clean area equal to the rest. With these tools I only need to sand with 400 or 600 to get a good finish inside boxes.

I hope you can see the difference. It's a small thing but I like my box interiors to be as good as the outside.

Top photo shows the lid turned with the hunter straight tool. You can see the area where it won't reach and where the scraper left it dull looking. The second shot shows the lid after using the shoulder tool. Shot 3 is a close up of this tool. The cutter topside is almost facing you. This allows you to make a cut coming back toward you and still rub the bevel for very clean cut. The last shot shows how the tool is used.








Re: cleaning up torn grain under threaded lid

#2

Mike Peace

Re: cleaning up torn grain under threaded lid

Mike Peace

What kind of wood is that, John? I see you are getting some burning with your cutter. What speed do you use with your jig? Wonder if taking a second pass after using some paste wax would help.

Re: cleaning up torn grain under threaded lid

#3

Keith Tompkins

Re: cleaning up torn grain under threaded lid

Keith Tompkins

Nice work John...Mulberry?

Re: cleaning up torn grain under threaded lid

#4

Re: rubbing the bevel

Steve Criscenzo

John

That is quite an improvement. I am trying to visualize the cut. Are you pulling the tool towards you as you cut. When you run the bevel, is the bevel just on the cutter or does the bevel angle continue down the end of the tool to give you more surface area (and stability).

Steve

Re: cleaning up torn grain under threaded lid

#5

Re: cleaning up torn grain under threaded lid

John lucas

Mike. I use a router for threading when I travel and it runs too fast. If you stop at all when your turning the theads it burns woods like cherry and Osage orange

Re: cleaning up torn grain under threaded lid

#6

Re: rubbing the bevel

John lucas

I'm pulling the tool toward me On this tool the cutter itself is the bevel. Sort of works like the micro bevels I put on most of my tools now

Re: cleaning up torn grain under threaded lid

#7

Cherry


Re: cleaning up torn grain under threaded lid

#8

great tool

GaryG in MD

I use it for what it's designed for -- the hard-to-reach area right around the inside shoulder area immediately surrounding the small opening of a classic hollow form, but you've definitely found another great use for it.

It has a bit of a learning curve.

It works great in a "pull" mode.

I find it very catchy in a "push" mode and have learned NOT to do that!

...GG