Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Question: Gear Shift Knob for 2008 Mustange.

Posts

Question: Gear Shift Knob for 2008 Mustange.

#1

Alan Sweet

Question: Gear Shift Knob for 2008 Mustange.

Alan Sweet

My God-son saw some of the bottle stoppers I have made and asked an interesting question. Could I turn a gear shift knob for his Mustang. (He has a stick shift.) The turning does not seem a challenge. It is the attaching it to the gear shift lever. When looking into it, I find there are all kinds of attachments for leather casings and holders.

Has anyone done this? If so any advice?

Re: Question: Gear Shift Knob for 2008 Mustange.

#2

Re: Question: Gear Shift Knob for 2008 Mustange.

Stuart Johnson

If it screws on you should be able to find a nut the right size. Drill a hole and epoxy in the nut. Use a bolt in a drill chuck to hold it and turn it like a bottle stopper.

Re: Question: Gear Shift Knob for 2008 Mustange.

#3

Re: Question: Gear Shift Knob for 2008 Mustange.

TomB

Kegworks (KegWorks.com) has ferrules and hangar bolt for tap handles. They come in several sizes, and I think you would find a fit. I use my threaded 3/8" stopper mandrel to turn the tap handles, and I know it also fits several on the floor models for car/truck gear shifts, but not sure about that one.

Re: Question: Gear Shift Knob for 2008 Mustange.

#4

Re: Question: Gear Shift Knob for 2008 Mustange.

Lan Brady

I have turned several shifter knobs for older cars. I used a threaded insert instead of tapping the wood to fit the shifter. (May have been overkill)

I just felt the shifter knob was going to get a lot more use than a bottle stopper would.

Good luck the knob will be talked about often.

Lan

Re: Question: Gear Shift Knob for 2008 Mustange.

#5

Brass threaded insert

John Lucas

I only made one but it had to screw on and line up exactly right. I left the bottom end longer than needed by a hair and used a brass insert. Then I could screw it off the mandrel and try the fit. If the knob didn't line up correctly I put it back on the mandrel and took off a hair more and checked it again. Your gouges will easily cut the brass. I suppose you could also sand or file it until it aligns. of course if your knob is just round then it doesn't matter. Mine had a tilted top and I engraved the shift pattern on it.

Re: Question: Gear Shift Knob for 2008 Mustange.

#6

pretty sure it is a 12mm x 1.25 pitch


Re: Question: Gear Shift Knob for 2008 Mustange.

#7

Re: Question: Gear Shift Knob for 2008 Mustange.

Ken Daniels

It is easy to turn a gearshift knob, I turned one for my fathers Studebaker with a modern dodge chassis. I epoxied a nut on the base, inserted a Studebaker logo on top and filled with acrylic, then did an offset turning on the knob. Your Mustang would need a 12 x 1.25 metric nut to fit your car.