Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Bowl with a hole

Posts

Re: Bowl with a hole

#26

Re: thanks for the help

phillip Medghalchi

Steven, do not ground it, or use saw dust. I have done it and the result is too obvious for a repair look. what happens that the grain of saw dust or grounds are different diameter so when yo use thick CA or epoxy it will show through and it comes out like it has full of dots in it. What I have done is that grabbed and saved lots of walnut bark and then I use my spindle sander with a fine grit sanding sleeve in it. make sure that you clean and blow out the table that you do not mix any other dust powder in it. then I go for collecting the fine dust powder. You can mix it with your epoxy and fill it in or you can use thick CA and plug up the other end of the hole with tape and then build up your hole. when you go to sand it will give you a nice result. I am working on a piece of God Knows what kind of wood (suspect to be ash) how ever, when I picked it up and put it on the lathe there were not any knots or cracks or anything visible, but as I started to shape and hollow things started to reveal themselves and a big branch hole which was rotting showed up. fortunately I saved the knot, however, ithink I will fill it with the above remedy. I'll show it here soon.