Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Router Mount Version 2

Posts

Router Mount Version 2

#1

Router Mount Version 2

Steve Criscenzo

I posted my original router mount a few weeks ago. After using it and receiving a few suggestions, I have made version 2.

The major changes are, the cross feed vise can now rotate relative to the face of the turning and I made the mounting for the router much stiffer.

To allow it to rotate, I made a circular base that included two slots for the hold down bolts. I added a third track down the center of the table with a corresponding guide rail on the bottom of the circular platform. This assures rotation about a constant axis and allows for much easier adjustment. The first photo shows the underside of the base. (Before I took it apart I used the Version 1 system to make the stopped slots in the round platform.)

I eliminated the plastic from the router mounting assembly to the vise to reduce flex. I had some 3/8 thick aluminum channel that I cut to make the angle to attach to the vise. I used 1/4 aluminum plate to attach the router base to the angle. It is now very stiff and I do not think there will be flex when using.

The second and third photos show the front and back side views. The last photo is a detail of the router mount assembly.

It will be a week or two before I get a chance to give this a go. I will post results.

Steve


Re: Router Mount Version 2

#2

Re: Router Mount Version 2

phillip Medghalchi

Steve, the whole idea is great. Where does the clamping or the grey contraption is from that is the most important part of the whole deal.I think if one doesn't have that this idea is not replicable.

Re: Router Mount Version 2

#3

Re: Router Mount Version 2

Philip F Duffy

Have you thought about marketing this new version? Seems like a winner to me. Good luck with all this effort. Philip

Re: Router Mount Version 2

#4

Re: Router Mount Version 2

Don Orr

Nicely done-looks solid and versatile.

Re: Router Mount Version 2

#5

Re: Router Clamp

Steve Criscenzo

Philip

I assume you are referring to the router clamp shown in the last photo. The top part, the part that actually holds the router, is the base that came with the router. I just took the plastic off the bottom. The other two pieces are in the photo are a piece of aluminum angle that clamps to the table of the vise and a vehicle piece of 1/4 inch aluminum plate. All pieces are held together with bolts threaded into tapped holes.

I will post some process photos when I get time

Steve

Re: Router Mount Version 2

#6

Re: Router Mount Version 2

Steve Criscenzo

Philip

Thanks for your comments.

There is really nothing special about this setup (other than I made it) and I think.there is probably already something similar in the metal working world. I enjoy the design evolution and fabrication process but this is a hobby so I think I will leave production to others.

Steve

Re: Router Mount Version 2

#7

Re: Router Clamp

phillip Medghalchi

Steve, that's not the part I am talking about. This one in the pic.

Re: Router Mount Version 2

#8

Re: Router Clamp

Steve Criscenzo

Philip

Sorry about that. The device in the photo is a cross feed or cross slide vise. It is common in metal work milling operations. I rescued the one I have from a junk pile 20 years ago. I have seen versions of this vise at Harbor Freight for about $80.00.

Steve