Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Processing Burl

Posts

Processing Burl

#1

Processing Burl

Doug Reynolds in Seattle

A woman had a very large locust tree taken down here in the Seattle area this week and offered me some of the burls which are still attached to pretty large limbs. I usually turn small bowls as I only have a mini-lathe and wonder, how I should go about processing and using this burl. Should I cut it up as I would for making bowls and, do I need to rough turn them, coat with Ancorseal and, let them dry for a year per inch plus a year? Thanks for your advice. The tree service would otherwise have put this stuff through the chipper or sold it as firewood.

Re: Processing Burl

#2

Steven Antonucci

some thoughts

Steven Antonucci

I like to cut them out in the round to balance out the eyes. If they are large, I plunge cut in around the burl.

If you turn them green, some burls will get a ripply surface. You might like that? If you let it dry, they are hard to sand. If you leave it thick, you can return to a flat surface...

S

Re: Processing Burl

#3

George Balock

Re: Processing Burl

George Balock

Doug,

Before anyone else says it, Send it to meeeeeee! In all seriousness, the size of the lathe only limits the size of the blank that can be turned. Cut the burl into sizes you can turn, rough turn what you can as quickly as you can and wax it with Anchor Seal . Good luck with a nice find.

Re: Processing Burl

#4

Re: Processing Burl

Dave Staeheli

Because it is locust, don't try to dry it out in large pieces! I've been getting pieces of this for years and have not had any luck trying to dry thick rounds. Lots of long checking after sealing. Been getting luck with peppermill sized pieces. I don't know about rough turned bowls.

Re: Processing Burl

#5

Or leave them large, in the shade, on the ground

Keith Newton

And keep them wet. If they were mine, I would want to work this hard wood start to finish while green/wet. It is twice as hard when dry.

Re: Processing Burl

#6

Brad Vietje

Re: some thoughts

Brad Vietje

I like those ripples, so I turn many burls to completion in one go, wet sand, then after air drying, clean up the fuzz from raised fibers with Scotch Bright pads cut into pieces to fit a hook&loop sanding pad -- gets rid of the fuzz w/out sanding away the texture.

Have fun!

Safe spinning,

Brad Vietje

Newbury, VT

Re: Processing Burl

#7

Re: Or leave them large, in the shade, on the grou

phillip Medghalchi

Doug, if this is your first time turning black locust then be aware that it contains silica and will tear your tools up, so be prepared for it. I didn't know it had silica in it and I got a log from a friend who sells them in Vancouver, WA down the road from you. If you want you can pm me and I get you the info to talk to him to help you maybe to dry them properly. Mine was waxed and somewhat wet not that much and I turned it during the summer, here in S. TX and I can tell you that our high temp dries the heck of anything left even out of the sun. So I didn't have any problem with that. I don't think I have the pic. of the bowl yet, I try to send it to you so you can see. Mine is not burl, however, I think yours would be even more dramatic since it's a burl.