I just looked at the next 10 day forecast. I'm going into hibernation. I hate cold weather. I was able to ride the motorcycle today and got a lot of testing done in the shop. However it's going to be 30 degrees cooler tomorrow but the night time temperatures are what make my shop so darn cold.
It takes a very big electric heater. I have a propane and a Kerosene heater and on days where it's in the 20's I can't get the shop above about 45 maybe up to 50 if I'm lucky.
Dad always told me to look around the corner to find someone worse off than me. It is going to be minus 15 tomorrow night here in Maine and the wind is going to pick up too. I am planning on staying inside for a couple of days.
I do feel for you though if you can't get the shop warm. That can't be any fun at all.
When I rode home last night it was about -13C (9F). Made the mistake of stopping for some things at the store and took my gloves off to load the saddle bags. Good thing I was only 1/2 a kilometer from home.
It's -19 (0F) this morning and I ain't going anywhere.
I think hibernating for a few days sounds like a great idea, John.
I have nothing but an infrared heat lamp, and since my lathe is out in an unheated barn in Northern VT, I hear ya on the cold turning! However, I might define cold a little differently; to me 45 degrees would be great during the winter!
I need to get a heated shop set up, but till then, I need to wait until we get up into the 30's or better to work out there for any length of time. It would help if I stored the tools indoors, since they would be a whole lot nicer on the hands when warm.
We had a high temp of about +5F today, and -15 to -25 (F) expected by morning, and tomorrow's high temp is supposed to be about zero; I'll be sitting near the wood stove with a good book or watching a movie on the computer, and dreaming of what a luxury a 45 degree shop would be .