Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Woodcraft Turning Class!!

Posts

Woodcraft Turning Class!!

#1

Woodcraft Turning Class!!

Tom

Well yesterday I spent the day taking an intro into Turning at the Woodcraft store. I thought that if I am going to get back into it I need to do it right. Had an opportunity to try some different tools and the lathe, a Jet with VFD, was really nice. Ended up with a mahogany mallet.

Have a question for you guys. Since I am still up in the air about doing some upgrades on my older Rockwell lathe by getting a 3ph motor and VFD I was wondering if you might have some ideas. Does anyone have a homemade set up for using a motor with a steeped pulley? Mine motor is currently fixed in place and I have to manhandle the belt to switch speeds. The lathes at Woodcraft had a "release" for the motor that allowed easier belt changing.

Thoughts? Pics??

Re: Woodcraft Turning Class!!

#2

Re: Woodcraft Turning Class!! *LINK*

Bill Howatt

Here is one a guy did for a metal lathe. It uses the "over-center" principal. He also mentions why the simple method of hinging the motor in contractor saw fashion didn't work.

The basic idea is shown but you will have to do a bit of anatomy-scratching to adapt it to your setup.

On an old lathe I tried the hinged method and while it did seem to be not too bad as far as power transmission went I did think the vibration increased. I thought of stabilizing it with bolts with knobs for easy turning but I think the method has to be real convenient or it will just be a different kind of misery.

IIRC, the motor on my General combines an over-center handle with the motor mounted on a hinged platform.

BIll


Belt Tensioner Pictures

Re: Woodcraft Turning Class!!

#3

Re: Woodcraft Turning Class!!

Barry Irby

Many years ago I had a lathe with the motor mounted behind it. The motor was mounted on a piece of plywood that had a four inch door hinge on it. There was a four step pulley on the lathe and another on the motor. It worked OK for spindle turning. Can't remember turning a bowl on it. You might need a weight on the motor. One of the good things was that if you get a catch the motor will climb and or slip.

Re: Woodcraft Turning Class!!

#4

Harry Robinette

Re: Woodcraft Turning Class!!

Harry Robinette

Tom

I believe you were at the Woodcraft in Cleveland if so I'm in Stow 35 minute's south from there contact me and I'll try to give you a hand. Have done 2 change over to 2hp 3ph with VFD in the last year or so.

woodspinner@ neo.rr.com

Re: Woodcraft Turning Class!!

#5

Re: Woodcraft Turning Class!!

Tom

Thanks Harry! Yes that is where attended the class. Will be in touch.

Re: Woodcraft Turning Class!!

#6

Re: Woodcraft Turning Class!!

Cyril Griesbach

Well done, Harry. Another example of how sharing woodturners are and willing too help each other out.