Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

EggBot egg

Posts

EggBot egg

#1

EggBot egg

Hal Taylor

Recently Clay Foster posted pics of egg ornaments and showing how he made them. In addition, Leo Cuellar commented about using an EggBot to draw on the eggs. Since I have an EggBot I was stimulated to try doing a Christmas theme drawing. The pic shows a wreath drawn by EggBot and then I pierced the center portion out. (The interior of the egg had been dyed orange from another project.) Now all I have to do is follow Clay's lead.

Re: EggBot egg

#2

Leo Cuellar

Re: EggBot egg *LINK*

Leo Cuellar

Pretty cool, Hal! I haven't gotten an eggbot yet. I just ordered one of these to help with some patterns & stencils for flatwork and fiber arts.


silhouette cameo

Re: EggBot egg

#3

Re: EggBot egg

Hal Taylor

Thanks Leo. I've looked at the Silouette also. Let me know how it goes.

Re: EggBot egg

#4

Re: EggBot egg

Craig Daymon

Looks good Hal.

Did you get the regular EggBot or Ostrich EggBot?

Re: EggBot egg

#5

Re: EggBot egg

Hal Taylor

Craig, I got the smaller EggBot, but I think I should have gotten the larger. I have wanted to try some turned ornaments and the smaller EggBot may be too small.

Re: EggBot egg

#6

Re: EggBot egg

tomB

This is cool. I went out to the web and looked up the Eggbot site. This looks like something that could be adapted to use a hi speed carving pen in place of the colored pen, has anyone done that?

Re: EggBot egg

#7

Re: EggBot egg

Craig Daymon

I believe it's been done to etch glass, but I don't know if anyone has done it yet with wood. I think the plans are open source/hardware, so if you wanted to build a beefier one that could use a heavier rotary cutter, that might be possible. I think when they etch glass, they are using diamond dental bits and a micro motor of some sort.

Re: EggBot egg

#8

Re: EggBot egg

Hal Taylor

Tom, in fact, that's one reason I got the EggBot. I have tried it out using an NSK Presto, and it does work somewhat, at least on eggs. It will take lots of tweaking though. For me, I have found it better to draw a pattern then cut by hand, but I have not really tried to tweak that much.