Re: A TECO
Josh Bowman
Tom, That's the one I bought. A friend at SMC also bought one ahead of me. Like John Lucas said. I played a lot with the parameters (kind of like messing with a smart phone). Only one parameter really remained changed and that had to do with "slip". I found the factory setting kept the motor on speed (or frequency) and if it tried to slow down due to loading, it would shoot the current to the motor and the VFD would shutdown on over current. This only happened at real low speeds, like 50 rpm and really loaded. So I changed the parameter and that fixed the problem. As for a wood lathe, that should not be an issue, since at 50 rpm you aren't really going to load up the motor. If you get 220 volt or 120 volt, remember you only need heavy 12 or 14 gauge wires to the motor and the power cord. The "control" voltage for the on/off switch and potentiometer only needs to be some lite stuff, like phone wire, since it's only at about 24 volts and almost no current.
You need to pick up from Radio Shack 271-1715 10 ohm pot, and 275-0654 SPDT (single pole double throw) switch. At least that's what I used on my 1 HP TECO VFD.
Rule 1, these things were not made solely for wood lathe users. I'm thinking computer controlled widget makers in large factories. That's why they have so many options.
Rule 2, hook the power and motor up and run it without any other external controls. You can raise and lower speed and turn it on and off with the control VFD box.
Rule 3, change and record the change of any parameter, so you can put it back.
Rule 4, when you're ready to hook up the external controls, do one at a time (on/off switch or pot) and test it. Also ask and I'll send you some pictures. Or go to SMC and search for Monster Lathe Update thread. David, had a bad motor that he got a a flea market and that caused a lot of problems. If you get this rig from Dealers Electric, you'll have little problem. BTW the motor you get is NOT like wired to the VFD. It's not hard, but those wire numbers were real hard to read. You might want to borrow a kid with good eyes to read them for you!
All in all you'll love it. The unit takes my old metal lathe up and down as smooth as silk. After I got over playing with the options and just started using it, I find it to be very reliable. I feel it's some smoother than my Delta VFD on my PM3520b.