Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Punky problem with Ambrosia Maple

Posts

Punky problem with Ambrosia Maple

#1

Punky problem with Ambrosia Maple

ken chase

My first two projects with Ambrosia Maple were great. The current one has some areas on the surface

that are PUNKY and even sanding won't produce a smooth surface.

Is there a solution or should I just give up.

Thanks

Ken

Re: Punky problem with Ambrosia Maple

#2

Re: Punky problem with Ambrosia Maple

Peter Lamb

I have used the following with some success; Min-wax Hardener, thin CA, sanding sealer and white glue

Good luck

Re: Punky problem with Ambrosia Maple

#3

Ric Taylor

Re: Punky problem with Ambrosia Maple

Ric Taylor

Ken,

You can mix up a 50-50 mixture of lacquer and lacquer thinner and really drench the area until it won't absorb any more. If you cut deeper into the surface below where the mixture has soaked, you will have to do it again.

This will stiffen the wood, it sands easily, doesn't change the color of the wood or stain it like CA will, and does not effect the finish that you put over it.

Ric

Re: Punky problem with Ambrosia Maple

#4

Re: Punky problem with Ambrosia Maple

John Lucas

I will also sometimes use diluted shellac but mostly use thinned lacquer. About the only problem is they tend to clog the sandpaper. I use a file card to clean the sandpaper if the crepe rubber bar doesn't work.

Re: Punky problem with Ambrosia Maple

#5

George Balock

Re: Punky problem with Ambrosia Maple

George Balock

Keeping the heat down by sanding slowly with lighter pressure will limit, but not eliminate the paper clogging with the lacquer solution. I've also used Venture(?) acrylic floor polish to fill in punky wood. It sands a little easier than the lacquer solution, but takes longer to dry.

Re: Punky problem with Ambrosia Maple

#6

PC Petrifier (at Home Depot and Ace Hdwe) *LINK*

mjonesrdg

I've used this product a couple of times and was very pleased with the results.


PC Petrifier