Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Lazer pointer dilemma

Posts

Lazer pointer dilemma

#1

Lazer pointer dilemma

ken chase

My laser pointer is from Craft Supplies. It's Sunday and I can't call them for help.

I remove the batteries between projects. I'm hollowing a form and after installing the

batteries instead of a single pin light I'm getting two arrows pointing to a center mark.

I have no idea why and which portion of the light I should reference for my wall thickness.

Any advice will be greatly appreciated.

Thanks

Ken

Re: Lazer pointer dilemma

#2

Re: Lazer pointer dilemma

Bill Howatt

Sounds like it has changed "mode".

For now, can't you temporarily setup something like a flat board and see where the new mark is relative to the tool?

Bill

Re: Lazer pointer dilemma

#3

Re: Lazer pointer dilemma

John Lucas

Doesn't matter which dot you use as long as you use the same one each time. The only laser pointers I've seen that had different symbols or dots Han interchangeable tips. Perhaps the tip has simply come unscrewed a little and is refocusing the spot

Re: Lazer pointer dilemma

#4

Brad Vietje

Re: Lazer pointer dilemma

Brad Vietje

I think John has it, Ken.

If the front lens is getting loose, it could be giving you a goofy image with a primary spot and an off-axis reflection (?) Maybe you can see if the front element will snug up, or is the tiny lens is now held in there at an odd angle. Pretty understandable given the vibration that these things deal with.

If you remove the cutting tip from the vessel, and adjust the light using a white card, you should still be fine, as Bill suggests -- just be sure to remember which arrow or dot you are using.

Safe spinning,

Brad Vietje

Newbury, Vt

Re: Lazer pointer dilemma

#5

Re: Lazer pointer dilemma

John Lucas

I use one of the quarter size rare earth magnets painted white with a line and makings for wall thickness. Then I just attach the magnet to the tool tip and adjust the angle to be perpendicular to the side where I'm cutting. Then I adjust the laser

Re: Lazer pointer dilemma

#6

Lyle Jamieson

Re: Lazer pointer dilemma

Lyle Jamieson

If the laser (like mine) has a tip, take it off. The tip is interchangeable with different symbols on them. Just take it off, it is usually only cosmetic.

Re: Lazer pointer dilemma

#7

Re: Lazer pointer dilemma

ken chase

Thanks. I'll give it a try in a couple weeks when the splint comes off my right index finger.

Had a fight with my band saw and lost.

P.S. Using your Carbide tip assembly and enjoying it very much.

Ken

Re: Lazer pointer dilemma

#8

Lyle Jamieson

Re: Lazer pointer dilemma

Lyle Jamieson

OOOCH!! That's why I don't use a band saw. Heal quickly and completely. Thanks for the feedback. In the meantime enjoy the Holidays.

Re: Lazer pointer dilemma

#9

Re: Lazer pointer dilemma

steve worcester

two arrows sounds like there is a lens on the laser. A lot of laser pointer type lasers will come with different lenses. Like Lyle says, see if it is removable to it's dot.