Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Cracks in CA finish

Posts

Cracks in CA finish

#1

Cracks in CA finish

Chuck Engstrom

Has anyone else out there gotten cracks in a CA finish like those in the photo? Any ideas on what caused this or how to prevent it? (This is larger than lifesize as I preview it on my screen, it's a bottle stopper top.).


Thanks -- Chuck

Re: Cracks in CA finish

#2

Re: Cracks in CA finish

Dick Coers

I've been reading quite a few questions lately about cracking CA. One idea was about moisture because the guy had wiped the wood with denatured alcohol before finishing and the common idea was that there was some water in the alcohol. Other than that, I've seen no definitive reason.

Re: Cracks in CA finish

#3

Alan Sweet

Re: Cracks in CA finish

Alan Sweet

I had some problems in the past with oily or waxy woods with a CA finish. A couple weeks after completing, i have had cracking or complete separation of pieces of the ca finish from the wood. I used various cleaning things but the best I cam up with was using a very thin shellac wash before applying the CA.

Again I attributed my problems to oily or waxy woods

Re: Cracks in CA finish

#4

Re: Cracks in CA finish

GaryG in MD

I've had this happen on two pens, but I attributed it to stresses from the pressing operation.

On the first one, I had possibly left a little CA on the end of the tube and hence directly where it would be pressed on. So I have started to be very careful to sand the ends flush.

But it happened again. This time, I attributed it to just pressing too hard, trying to get a perfect fit.

Now I'm not so sure.

The two woods I used for the above were maple and amboyna burl. The former is obviously not oily, but I did press against the CA on the ends on that one.

There may be multiple causes for the problem. I doubt Chuck "pressed" on his stopper blank.

I'm also wondering if temperature could be an effect. Perhaps putting the CA on at a cold temperature and then having the piece expand when it gets warm? That might be understandable -- and bad news for CA-finish users. This effect would be worse for larger pieces too. Pens probably would expand a lot less than a bottle stopper.

I really want to learn more about this too. Has anyone else seen this happen? ...GG