Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Electronics for a Nichols Lathe

Posts

Electronics for a Nichols Lathe

#1

Electronics for a Nichols Lathe

Nick Todd

After not using my Nichols Lathe for an extended period, I plugged it in. I typically use the speed control to operate the lathe. By chance I happen to use the on/off switch the turn the lathe off. The switch failed to turn off the motor. Removed the switch, and the motor ran.

Several Years ago I had a pdf of the manual, but that went with a crash hard drive. I won't be able to get the controller box until this weekend(it's up against a wall.

Are there any ideas?

Re: Electronics for a Nichols Lathe

#2

Re: Electronics for a Nichols Lathe

Josh Bowman

Nick, does the electronics have a name brand, like Teco or Delta?? If so you may can salvage it. The above two run the controls on low voltage and low current. When dust get into them, they fail.

Re: Electronics for a Nichols Lathe

#3

Re: Electronics for a Nichols Lathe

Bill Howatt

I remoted my General's on/off switches and every now and then I have to blow them out to get it to turn on. Looking at my setup, I just can't believe dust could get into the switches but it does.

Bill

Re: Electronics for a Nichols Lathe

#4

Re: Electronics for a Nichols Lathe

Nick Todd

The name started with an "M". I have to move some stuff around to get at the control box. The box has to be opened to see the name. Looking at the wiring at the switch & speed control, I am sure they are low voltage.