Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Tool Holder prototype

Posts

Tool Holder prototype

#1

Tool Holder prototype

Ray - Middletown, IN

Barry's post prompted me to post the prototype tool rack I started some time ago. I may even finish it sometime. First I took an old computer chair apart and used the bottom and a piece of PVC pipe.



Then I made a collet of some piece of wood, cut a small piece of plywood, and got a 4" lazy susan.



and the assembly



Next I cut a 15" round of plywood and cut a bunch (15 I think) of holes on a 15 degree angle.



Here is the thing put together. I left the PVC long for more shelves, or maybe a place to hang a shield or jacket. A five legged version would be more stable and I have acquired one for the next version.



Ray

Re: Tool Holder prototype

#2

Re: Tool Holder prototype

mjonesrdg

If it is stable, it is the best that I have seen! Nice job and great idea!

Re: Tool Holder prototype

#3

Re: Tool Holder prototype

Ed Wujciak

If it seems top-heavy, add weight to the base. Assuming you use it on a hard, smooth, level surface, the weight will not measurably diminish its ease of movement.

Re: Tool Holder prototype

#4

Re: Tool Holder prototype

Barry Irby

I like it, but my shop is rarely that clean and I have a soft rubber mat in front of the lathe. I like the mat, but it is the bane of my existence when I try to roll stuff around. I would want seriously bigger wheels and it would need some ballast. The ballast could be stuff stored down low.

Re: Tool Holder prototype

#5

Here is a tool rack design that .......

JamieDonaldson

....I made years ago to stand near my lathes, and it hold only the tools needed for a specific project. The diagonal magnetic knife holder works just fine when inclined slightly, and I can move the stand around quite easily for cleaning. Base is also an old office chair.