Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Drilling a lamp post

Posts

Drilling a lamp post

#1

Drilling a lamp post

Jorge

I am making a lamp post and my Powermatic 35-20b does not accept my 5/16" drill.

I used that long drill many times when I had a Delta Midi, I made lamps and recorders (flutes).

And the PM live center seems to be able to accept a drill, as it is hollow. But not my 5/16""

What gives?

Re: Drilling a lamp post

#2

Re: Drilling a lamp post

Chuck Engstrom

Hi Jorge -- Very strange. My 3520a takes a 3/8" lamp drill through the tailstock no problem, and my Oneway live centers take a 5/16" drill without any binding.

--Chuck

Re: Drilling a lamp post

#3

Re: Drilling a lamp post

Jorge

Thanks Chuck,

I'll borrow a OneWay live center an get the job done, then will take this live center to a machine shop and have it bored.

Re: Drilling a lamp post

#4

Re: Drilling a lamp post

John Lucas

I use a nova Live center to bore lamp holes using my 3/8" lamp auger.

Re: Drilling a lamp post

#5

Thanks John


Re: Drilling a lamp post

#6

Re: Drilling a lamp post *LINK*

John Lucas

I have a special tail center I bought from Peter Child (I think) It is a short #2 morse taper and has a removeable center point. It is a dead center but it fits nicely in the Nova live center. What I do is align the point with the center of my blank. then I loosen the setscrew so I can easily push the tailstock in until the cup part of the center is pushed into the wood. This leaves a ring shaped depression in the wood. Then I back off the tailcenter and remove the center pin and setscrew. Now it's easy to re-align the center without the center point. It has a 3/8" hole so the lamp auger will fit through. I drilled a hole through the set screw hole so once the setscrew is removed you have 2 holes to help clear the swarf from the drill bit.

I don't know if this is the same center sold by Craft supplies because you can't see the set screw but it looks like the same one. I would call them. It's listed as $9.95 in their catalog and $27.95 online. Hmmmmm.


http://www.woodturnerscatalog.com/p/4/-/12/65/-/5331/Precision-Machine-3-8%2522-Hollow-Center?term=lamp+auger

Re: Drilling a lamp post

#7

Re: Drilling a lamp post

John Lucas

forgot to say. It can be difficult to get the dead center out of the Nova live center. They both have 3/8" holes so you can't use the knock out bar. I put a rod through the setscrew and drilled hole and then tap on that with a mallet.

Re: Drilling a lamp post

#8

Re: Drilling a lamp post

Jorge

Thanks again John, I need to find the Nova live center, the bearing went bad and I stopped using it when I got the PM 5 years ago. Too much stuff in a small space.

Re: Drilling a lamp post

#9

Re: Drilling a lamp post

John Lucas

Wow I've had my Nova live center for probably 15 years and it still runs fine.

Re: Drilling a lamp post

#10

couldn't help myself   oh me oh my  *LINK*


http://www.youtube.com/watch?v=7-E2DmzvmPM

Re: Drilling a lamp post

#11

Great sense of humor John!


Re: Drilling a lamp post

#12

Funny thing

Jorge

Found the Nova live center and it is solid, no bore!