Hi All, Just got my lathe fixed and ready to start turning again. I have a project in mind and would love to get ahold of a nice piece of spalted maple with good figures in it. Looking for a nice piece of flat board to compliment a turning. Anybody know of a good source. I'm having a hard time finding any in the Seattle area. Thanks for your help.
I tried to find a web site for Vernon Leibrant, who is a member of the NWWoodturners. He does some of his own spaulting. I did find phone numbers, and he used to do the Best of the Northwest show there in Seattle.
Kelly - try http://www.nwwood.com. I think they're still operating through spring; used to be in the Bonney Lake area. With so much native Maple up here, and our usual moist climate, it can be hard not to find maple that's not in some degree of spalting...if it isn't spalted, leave it in the yard, give it a few minutes...
Thanks for all the responses. I only need a piece for the top of a box. 1/2" thick X 8" wide X 10" long. Since it going to be a fancy box with a special turning inside; I am making the body of the box out of Cherry and wanted a piece of figured Maple with a lot of streaks in it for the top.
Actually Chris is in Parkland (vrs Bonney Lake), last I heard plans to close by start of next year.
He got tired of fighting with the local County on zoning and such. He started out semi-rural and got enclosed by housing... Last time I talked with him he was planing to relocate, but I don't know to where