Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Programming DVR question

Posts

Programming DVR question

#1

Programming DVR question

Barry Irby

Did not want to hijack John's Hamster post, so I thought I would start another thread. I have a Nova DVR from 2002. (not the XP) As far as I can tell it has no breaking or slowing of the shaft. I thought I remembered that it was advertised as a feature. Does anyone know if it is supposed to be there or is available and if so how to program for it?

And if you have it on your lathe, do you like it or does it bother you? I stop it with my hand on the hand wheel, but I really don't like the holes in the wheel. How long do you suppose it will be before I jamb a finger tip in one of the holes.

Re: Programming DVR question

#2

Re: Programming DVR question

John Lucas

I have a love hate relationship with electronic braking which is why I was looking at the Hamster. When turning larger work it's a god send. I remember on my old lathe it would take half an hour for a big bowl to stop. Ok that's an exageration but it sure seemed like it. Naturally you reach up with your hand and try to slow it down which is really stupid and dangerous. With the electronic brake it slows to a stop in about 8 or 10 seconds or something like that.

The downside is on small work that I like to inspect often it also takes about that long. I get around that somewhat by using my mini lathe which doesn't have those features.

Thought it would be nice to be able to instantly adjust the braking and maybe ramp up speed but then who knows I might forget and end up sending a large bowl flying across the room.

My Powermatic got it just about right. It's there but not too annoying on smaller work and certainly save you on the large work.

Re: Programming DVR question

#3

Re: Programming DVR question

Mike Brazeau

Oneway have had two selectable braking speeds for years and a braking resistor is available that absorbs the energy. Works great.

Re: Programming DVR question

#4

Contact Teknatool?


Re: Programming DVR question

#5

Alan Zenreich

Re: Programming DVR question

Alan Zenreich

Barry,

I don't recall braking advertised as a feature.

You can, however, configure how/if the lathe stops in the event of a catch (a very cool feature)

Re: Programming DVR question

#7

Re: Programming DVR question

walta

Is far as I can tell the program modes effect the staring ramp up and if and when the motor will detect a jam and shut down the motor.

As far as I can tell the DVR has no electronic breaking at all.

I like it that way.

When I use lathes with electronic brakes it seems I want to stop faster than the lathe. So I grab the hand wheel but the lathe is on a pre programmed glide path and the motor is still under power and my hand will not change the speed of the motor, the only thing I get for my trouble is a blister hand.

Walta