Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Turning Tools Question.

Posts

Turning Tools Question.

#1

Alan Sweet

Turning Tools Question.

Alan Sweet

What is the easiest way to cut HSS Tool Bits? I have some 3/16 tool bits that are 2.5 inches long and I would love to cut them in half. They are 5% cobalt.

I have some HSS cutting blades for my hacksaw but for get it.

Re: Turning Tools Question.

#2

Re: Turning Tools Question.

Rich Egan

You have to score them first, then put in a vise and snap off with a big pair of pliers. Use a dremel with a thin cutoff wheel to score all around.

Re: Turning Tools Question.

#3

Re: Turning Tools Question.

robo hippy

You can also do it with a CBN grinding wheel if you have one of those. Use the corner of the wheel to score it. Do wear a glove, or put cloth/paper towel around the bit before you break it. Small shards can come flying off at a high rate of speed and poke holes in you. Eye glasses or face shield as well. Standard grinding wheel can also score the drill, but makes a rather large score line. Roll it around, and cut almost in half.

robo hippy

Re: Turning Tools Question.

#4

Alan Sweet

Thxs Rich & Robo

Alan Sweet

I wrapped a piece of leather around it before snapping it. and there was a couple small shrads of metal embedded into the the leather afterwards.

I usually learn those things by having the small bits embedded in me.

Re: Turning Tools Question.

#5

Steven Antonucci

I use vise grips

steven antonucci

Score with Dremel (one side is usually enough), then hold in metalworking vise at the cut line facing away and snap with vice grips towards me.

Any shrapnel flies away.

Steve