Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

walnut bowl blank

Posts

walnut bowl blank

#1

walnut bowl blank

art demers

I was given a nice walnut bowl blank that was waxed so I glued a nub to the end and started to turn lo and behold it took off like a ufo .Do you have to clean the wax off if so how does one do that ??? I've never used a waxed product before. thanks for any answers in advance......

Re: walnut bowl blank

#2

Re: walnut bowl blank - yes remove wax

Henry (Raleigh, NC)

Art - An unequivocal yes to removing the wax. The question is how.

I have no direct experience removing was from a blank I would typically use a face plate and screws into what I hope will be the top of the bowl blank (top of the blank to become top of the bowl). I mount the face plate and blank on the lathe and cut/shape/turn the bottom of the bowl, including a tenon. Once happy with the bottom, I reverse the bowl and use a chuck to hold the tenon. I then touch up any eccentricity in the outside, turn the inside, sand and finish.

To actually answer your question, I would scrape away any wax on gluing surface (don't bother with the other sides if they are waxed). Solvents such as Mineral spirits can be used to remove the residue. Personally even after that I would cut (bandsaw?) or rout about 1/8" or so of material to provide a fresh wood surface.

Once you have a fresh (flat) wood surface (wax free) to glue to, the glue block approach can be used as you would conventionally.

Henry

Re: walnut bowl blank

#3

Re: walnut bowl blank

Dale Gillaspy

Yes, you will need a clean surface for the glue to adhere to. If you want to use a glue block to hold the bottom of the bowl, you can screw a faceplate or screw chuck into what will be the top of the bowl. (You are going to turn that part away, so don't worry about the holes. That then gives you access to what will be the bottom of the bowl to turn away the wax and make a clean flat surface for the glue block.

You can also shape the bottom of the bowl at that time. Just make sure where ever the glue block will meet the bowl is clean and flat!

Re: walnut bowl blank

#4

I would be very hesitant to trust......

JamieDonaldson

...any use of a glue block on a previously waxed surface, even if considerable wood was removed in preparation. Wax can penetrate well into the wood, so I would use some mechanical method of mounting, in my case most often a chuck.

Re: walnut bowl blank

#5

Jesper, Denmark

Re: walnut bowl blank

Jesper, Denmark

Why not start between centers and turn a tenon for holding it in a chuck?

Re: walnut bowl blank

#6

Harry Robinette

Re: walnut bowl blank

Harry Robinette

I'm with Jesper on this one I do mine that way all the time.