Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Potential deadly piece of wood

Posts

Potential deadly piece of wood

#1

Potential deadly piece of wood

John Lucas

I thought I would pass this on. I was cutting out platter blanks this morning from dry wood. This one looked sound until you inspected it extremely close. In fact I would not have found it had I not done my usual test. As I cut off the corners I flex them or tap them on the workbench corner. If one breaks I suspect there could be a problem. On this piece 2 broke almost exactly opposite each other. I inspected the blank very very closely and could barely see the crack on one side. I traced the grain across and could see it on the other side as well. I could not see it on the back or the freshly cut edges. This was a heavy wood and that is about 1/3 or more of the piece that would have flown off once I cut started thinning it out. That would have been very dangerous.

When I cut green wood I typically cut 3 to 6" off the end to get rid of end grain checks. To make sure I make another cut about 3/4" thick and bang this on the corner of my cutting stand. if it breaks I off another 3/4" until I'm sure it's sound. Chainsaw cuts can often mast checks that are still in the log so look very carefully or do the test I do. The very first line of defense for safe turning is starting with sound wood.

I'll be turning ornament finials today so no danger other than possibly a paper cut from the sharp edge of a freshly cut edge or sticking my fingers into the chuck.

Re: Potential deadly piece of wood

#2

Re: Potential deadly piece of wood

Roger Chandler

Nice illustration...........thanks for the pic and the heads up on safety, John!

Re: Potential deadly piece of wood

#3

Re: Good Example

Steve Criscenzo

John

This is a great example of a pre-job safety routine that I tried to explain here last week. The fact that you have a process that you use both when cutting the blank with a chainsaw and prior to mounting it on the lathe demonstrates that you are evaluating hazzards and mitigating them before you ever step up to the lathe.

I too cut the corners off blanks on the bandsaw but never thought to "test" them. Thanks for the tip.

Steve

Re: Potential deadly piece of wood

#4

Re: Potential deadly piece of wood

robo hippy

I do a visual check first, and band saw and chain saw cuts don't really show anything up. Standing out of the line of fire, I turn it down the side and make a finish cut with a gouge and check again. This will show things a bit more clearly. I also do the 'cut a thin piece off and tap it on a table' to expose invisible cracks. Nice point to bring up John.

robo hippy

Re: Potential deadly piece of wood

#5

Very good lesson!

GaryG in MD

Thanks for showing your thought process and testing procedure.

You'll never know it, but you may have just saved someone's life. ...GG

Re: Potential deadly piece of wood

#6

Re: Very good lesson!

Mavdad55

Thanks for the lesson. Makes me want to only turn knarly grain wood to avoide those linear long growth rings