Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Eucalyptus Type ID Help Needed

Posts

Eucalyptus Type ID Help Needed

#1

Eucalyptus Type ID Help Needed

charlie belden

Joe, my tree trimmer friend, showed up with a trailer full of small branches and leaves - and six logettes of fresh cut eucalyptus in his truck bed. Interesting rippling on the outside of the four logettes I picked - the largest a larger crotch cut. Problem is, I don't know which of the approximately 400 types of eucalyptus it is - or if it's worth turning.

Anyone know which type of eucalyptus this is - and is it worth turning?






Re: Eucalyptus Type ID Help Needed

#2

Joe Fleming

Re: Eucalyptus Type ID Help Needed

Joe Fleming

The smooth gray/green bark suggests sugar gum eucalyptus. These are very common in southern California. The heartwood looks right too. You need to cut the pith out ASAP. Eucalyptus will check like crazy. End grain sealer is not enough. I had two of these taken down behind my house last week. The trimmer left four rounds in my yard around noon. I got home around 8pm and they are already checked to the point of becoming firewood.

Joe Fleming - San Diego

Re: Eucalyptus Type ID Help Needed

#3

Re: Eucalyptus Type ID Help Needed

charlie belden

This wood is from the SF Bay Area.

Looks like there's some very interesting figure in this wood - but is it worth turning if the wood is so unstable?

Re: Eucalyptus Type ID Help Needed

#4

Steven Antonucci

thinner turnings usually won't split


Re: Eucalyptus Type ID Help Needed

#5

Joe Fleming

Re: Eucalyptus Type ID Help Needed

Joe Fleming

Charlie,

I actually turn a lot of the stuff. You just have to process it quickly before it checks up. At a minimum, cut out the pith ASAP. Rough the wood into whatever you intend to make and green wood seal it. If you rough it, you will likely be OK.

Joe