Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Installed Doc's remote control in less than 30 min

Posts

Installed Doc's remote control in less than 30 min

#1

Aage Rendalen

Installed Doc's remote control in less than 30 min

Aage Rendalen

Thanks to Doc Green I now have a remote control for my PM 3520B. Not only was it very easy and quick to do, but it cost me less than $20. Here's a summary of Doc's recipe:

1. Open the start button panel.

2. Remove 4" yellow wire.

3. Insert a 16-2 gauge lamp cord into the headstock from the back.

4. Crimp on a spade connector on one line, a female connector on the other and attach them to the leads used by the yellow wire.

5. Connect a toggle switch to the other end of the line.

The only complication was that I had to grind down the outside of the 16 gauge spade connector from Lowe's to fit the PM's mount. The most time-consuming part was stripping the wires and crimping on the connectors. That says something about how easy this is, when you have Doc's recipe.

I bought 10 feet of wire and ended up using 9 ft. of it (I used another route than Doc's).

Re: Installed Doc's remote control in less than 30 min

#2

Re:Wonder how similar to a Jet 1642

Mike Hamilton

Anyone know if this is a pattern that can be borrowed? How similar the control setups?

Curious,

Mike

Re: Installed Doc's remote control in less than 30 min

#3

Re:Wonder how similar to a Jet 1642

Dwight Rutherford

I send you an Email

Dwight Rutherford