Birdhouse Bodies
Jeff Rich
This was some work this weekend.
These are birdhouse bodies Cheri and I make for the art fairs. 
Knowledge You Can Build On — Est. 1998
Birdhouse Bodies
Jeff Rich
This was some work this weekend.
These are birdhouse bodies Cheri and I make for the art fairs. 
Re: Birdhouse Bodies
Mavdad55
Jeff,
Nice, I can see you turned them all with a chuck; great job over a short time period. What is the smallest size in the picture, kind of hard to tell? I've only turned a few bird house ornaments and used jam chucks sized to the drilled out body size (via: Dale Nish).
Re: Birdhouse Bodies
Jeff Rich
The smallest is about 3.5 " tall and about 2.5 " diameter.
I hollow them with some tools I made based on David Ellsworths hollowing tools.
Re: Birdhouse Bodies
Mavdad55
I used a forstner bit to bulk out the center mass, then use a Dale Nish Hamlet tool to hollow them out. Works great, but the one I have is just a little to large, should have gotten the small one from Craft Supply.
http://www.woodturnerscatalog.com/p/7/2/33/138/-/1324/Hamlet-Dale-Nish-Formed-Scraper