Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

new ornament

Posts

new ornament

#1

new ornament

John Lucas

I'm putting together a handout for the demo I already did. I have updated how I use the router on the lathe and didn't have time to do one for them so I'm trying to do it now so they can get it in their newsletter. I thought I would do another ornament showing the technique.

I did the finial a lot better on this one. The upside down bowling pin shape is better. The two of them match more closely. I like the upper one to be a little larger both in size and length and I think I did good.

I always play with the shapes of the little saucers. Everything from slightly convex sides to slightly concave. Not sure what works the best but the convex ones are stronger. I've also done convex on one side and concave on the other. You can play with these endlessly.

I thought I had nailed the cove pretty well until I enlarged it. There is a flat spot at the thinnest part. Should have gone to my smaller gouge for this. It makes getting that tiny curve better.

Re: new ornament

#2

Re: new ornament

Barry Irby

May I be critical? If not, skip the rest of this and never worry about it again.

The thing you call and upside down bowling pin I call a vase. (That's not a criticism, just semantics.) I like them better when there is a little reverse curve or concave part in the thin part.

You are right about your cove, flat in the bottom. Good catch.

Your upper half bead does not match your lower half bead. They both should be more hemispherical.

And the icicle part should be more slender over all.

You are better at this than I am and free to ignore this and get on with your day. Its a beauty in spite of everything I said.

Re: new ornament

#3

Re: new ornament

Steve Criscenzo

John

Nice effect. I did not even notice the "flaws".

I am in the process of building your router table attachement based on your earlier posts. Would you be willing to share the handout with me. I would like to see your methods.

Thanks

Steve