Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Metal spinning a steel disk ? ? ?

Posts

Metal spinning a steel disk ? ? ?

#1

Metal spinning a steel disk ? ? ?

Pete in Holland, MI

Guys -

I need to make a replacement part for an antique tractor that may involve some metal spinning.

I need to make cover that would be about 12" diameter. The cover would be flat for the first 1-1/2" from the edge, then a gentle radius that would be result in a dish about 1" deep. Material needs to be steel, about 16 or 18 gauge.

Can steel be spun to create this dish, or is that asking a lot of a beginning spinner ?

Thanks !

Pete

Re: Metal spinning a steel disk ? ? ?

#2

Re: Metal spinning a steel disk ? ? ?

John lucas

The local company near me spins steel and stainless steel

Re: Metal spinning a steel disk ? ? ?

#3

Re: Metal spinning a steel disk ? ? ?

Dale Miner

Rumley clutch cover?

That thickness might be tough for hand forming from steel. If you do give it a try, drawing quality steel will be easier than commercial quality.

Thatpart might be easier to form with pneumatic plan wishing hammer.

Re: Metal spinning a steel disk ? ? ?

#4

Re: Metal spinning a steel disk ? ? ?

Dale Miner

I hate auto spelling correction (substitution is more like it.)

Re: Metal spinning a steel disk ? ? ?

#5

Re: Metal spinning a steel disk ? ? ?

Dick Coers

That's no place to start metal spinning. When was the last time you had luck stretching steel? It would take a LOT of force. If someone is spinning steel and stainless, there are either using hydraulics, or 6' long scissor tool. You would need a lathe to match that tool, LOTS of forces going into the head stock bearings.

Re: Metal spinning a steel disk ? ? ?

#6

If you can't find, what I would do.

Keith Newton

Google domed tank ends.

You should have an easy time finding a dome, that could be welded to the donut disk. Any good welder could join those two.

Re: Metal spinning a steel disk ? ? ?

#7

Re: Metal spinning a steel disk ? ? ?

Pete in Holland, MI

Sounds like I need to find other options for now.

Thanks all !

Pete

Re: Metal spinning a steel disk ? ? ?

#8

Re: Metal spinning a steel disk ? ? ?

Ralph Lindberg

Keith's idea is a good one.

I've worked 16 and 18 gauge mild-steel. I have a commercially made dome of 14 gauge. The facility used hydraulics to form the dome.

NO WAY could I form steel, by hand, like that. Well, except hot-work