OT: technology rant semi-applicable to turning
steven antonucci
Just got back from an oil change appointment for my 2005 Nissan Frontier. As I pulled out to leave, the tire pressure light came on with a loud, audible alarm. I was hoping that I hadn't picked up a nail, but since I was headed to the dealership and it didn't feel flat, I just drove there without too much concern.
As I started to think about it, I recalled about a year ago, I had the same thing happen. For those of you that do not know how tire pressure systems work, there is an RFID chip in the valve stem that sends a wireless signal (Bluetooth, I think?) to an onboard computer to report the pressure in each tire. The first time that the issue came about, I gave in and had them replace the RFID assembly in the tire @$250.
So the guy comes over and says..."Uh, it looks like the valve...blah blah. $250."
I think to myself, "OK, this is tire #2 to have this issue..." so I have $750 in future repairs coming...and the thing that tells me when the pressure is too low is the actual cause of the pressure being so low? And I have to pay for that?
No.
"How much to replace it with a regular valve stem?"
(I think I floored him with this question?)
$10, but the light will always be on...
Me: Done. I will tape over it with electrical tape so I don't have to look at it.
....
Which brings me to my lathe analogy. What percentage of lathe issues are due to applying superfluous technology? I had a bad bearing once, but almost ever other issue I have ever heard of was due to the electronics frying? Do we really need digital speed readouts? Do we really care if the lathe has a spinddown cycle? Or is that just something we see to create a service market for lathe repair/parts?
No doubt in my mind that the automakers are making these things fragile to feed the need for repair parts. Most cars are carrying 2 dozen computers (why not just 1?) for the various systems.
Discuss amongst yourselves.
Steve





