Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

PM 4224 Remote Switch

Posts

PM 4224 Remote Switch

#1

PM 4224 Remote Switch

Don Stephan

The remote on-off switch on my Powermatic 4224 only works for a few hours before fine dust gets between the contacts and makes it not work. And I keep the remote within reach but to the right of the bowl blank. The lathe was purchased used about six years ago and the remote was original equipment. Is there a newer PM remote that has solved this problem or a replacement anyone has had success with? Only takes a few minutes to disassemble and clean, but yesterday within a few minutes it stopped working again. After cleaning it tomorrow I'll slip in a plastic bag to see if that is a valid work around.

Re: PM 4224 Remote Switch

#2

Re: PM 4224 Remote Switch

Peter Hyde

Plastic bag worked for me. My 3520 hasn't had a dust problem in the remote since I zipped it

Re: PM 4224 Remote Switch

#3

Re: PM 4224 Remote Switch *LINK*

Doc Green

Here is an article that describes in detail how to install a remote switch on a PM 3520B, which probably uses the same circuitry as the 4224.

www.docgreenwoodturner.com/rems

I'm not familiar with the PM remote switch, but the thing that causes the main power switch to cause problems is that the contacts are slow-moving rather than snap-action. My suggestion is to replace the remote switch with a toggle switch that snaps.

Also on my website is an article on replacing the main power switch. It's in the new material posted in May 2013.

Good Luck! ~ Doc


Article on Remote Switch

Re: PM 4224 Remote Switch

#4

Links don't work!

Doc Green

The links provided in my reply above do not work, and I don't know why.

To work around, go to www.docgreenwoodturner.com

Then click on "New Material Has Been Added" on the home page. Scroll down ... There are two articles. The one on the remote is about a third of the way down the page.

Sorry about this. ~Doc

Re: PM 4224 Remote Switch

#6

Ted Calver

Re: PM 4224 Remote Switch

Ted Calver

I had the same trouble with my 4224. A ZipLock bag has worked for me for the last few years.

Re: PM 4224 Remote Switch

#7

Re: PM 4224 Remote Switch

Don Stephan

Thanks everyone, plastic bag it will be.

Re: PM 4224 Remote Switch

#8

Re: PM 4224 Remote Switch

Mike Gibson

My PM did not come with a remote so l added one with a waterproof box $10 from Amazon, so far l have had no problems.