Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

General Wood Lathe

Posts

General Wood Lathe

#1

General Wood Lathe

Kelly M. Robison

Help!!! I have a General Lathe model # 25-200. I have had real good success with this unit until today. I was turning a 8 inch bowl on it [various type of wood] and the bowl gouge caught and the motor turned it self off. In the past whenever this happened; I just hit the switch, waited a few minutes then turned it back on and kept on turning. This time, on the digital face I got a read out that said: SAFE. Now I can't re-start the motor. What is the secret????? How do I re-set the unit so that I can finish the bowl. Do I have to call the company in Quebec???? I realize that I may have over loaded the motor a little bit; but hasn't everybody pushed the limit at one time or another. Hey fellow turners help me out here; I need to finish this bowl for a graduation present for my granddaughter.

Thank you,

Kelly in Port Orchard

Re: General Wood Lathe

#2

Keith Tompkins

Re: General Wood Lathe

Keith Tompkins

Kelly, try unplugging it for a few minutes, then retry.....

Re: General Wood Lathe

#3

Did you unplug it?

Dick Coers

reboot works on computers, maybe it will work on controllers? Just guessing.

Re: General Wood Lathe

#4

beat me by 1 minute!


Re: General Wood Lathe

#5

Re: beat me by 1 minute!

Bernie Rose

Unplugging worked just fine on my 260 ----- that is until I blew the whole controller and the company wanted $1100 for a new one.