Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

cutting black pipe for clamps

Posts

cutting black pipe for clamps

#1

cutting black pipe for clamps

Brad Bransky

Before I ruin a hack saw blade, I thought I'd check with you all for advice. Black pipe for Pony clamps can be bought cheaply in ten foot lengths. Can they be cut with a hack saw?

Incidentally, a few weeks ago I asked what causes edge snipe at the end of a cut on the jointer. I got some good answers and advice. I discovered the culprit is too much hand pressure on the rear end of the board as it crosses the blades. If I keep my hand well in front of the right end of the board I get no snipe. So thanks to which of you suggested same.

Brad

Re: cutting black pipe for clamps

#2

Re: cutting black pipe for clamps

Brad Bransky

Ooops! Sorry, wrong message board. Brad

Re: cutting black pipe for clamps

#3

Rob Wallace

Re: cutting black pipe for clamps

Rob Wallace

Brad:

I have cut black pipe with a bimetal blade (Dewalt) mounted in my Sawsall; use slow speed with modest pressure, and let the blade do its job. It took some time, but cut fairly well. A few drops of cutting (threading) oil can extend the life of your blade if applied a few times during the cut.

Rob

Re: cutting black pipe for clamps

#4

Re: cutting black pipe for clamps

bill Crommett

Better yet, use a pipe cutter. Less effort, smoother ends , less filing.

Re: cutting black pipe for clamps

#5

Re: cutting black pipe for clamps

Don in Central Illinois

At our local Ace Hardware, I just tell them I need two five footers ( as an example) and they cut and thread the ends at no extra cost.

Re: cutting black pipe for clamps

#6

I found that some big box stores....

JamieDonaldson

...that specialize in building supplies have a selection of pipe cut to a variety of lengths, and already threaded for the clamps. I also prefer galvanized pipe that doesn't rust and make a mess on my project glue-ups.