Shop tip, not turning related...
steven antonucci
unless you use files to refine you work post lathe?
So I have a drawer full of old files, and I have read frequently that they can be sharpened with muriatic acid, so I bought a gallon...did a little reading... and then set about it last night while carving a spoon.
Firstly, muriatic acid is strong stuff, so don't screw around with it. Work outside in a well ventilated area. When the breeze picked up last night, both my son and I would notice it... and it is bad stuff. Aside from not wanting to breathe it, it will rust everything in your shop if you work inside.
I used a 5G bucket from HD tilted at an angle, with the bucket essentially laying sideways on the ground and a slight downhill slope. Placing the files in it first, I added enough acid to cover them. 30-40 minutes later, I went back to a greenish bubbling mess.
Once the files have been etched, you need to stop the chemistry. Using a couple of tablespoons of baking soda in water created a neutralizing solution. I removed one file at a time, and placed it in a similar bucket arrangement of the second solution. It fizzled violently for a second or two, and then I would go get another one. When they were all moved, I let them sit for 5 minutes.
Once the files are neutralized, I dried them and sprayed them with WD-40 to try to prevent rust. I can feel that the ones that were just a little dull feel like new files. The ones that were a lot dull could probably have used another few minutes in the acid bath.
To dispose of the acid, I simply pour (slowly) the acid into the baking soda solution, and then dilute with a couple of gallons of water before dumping.
Simple and effective. Now, I just need to do it 5 more time for the other 25 files I own...or get another container 
Steve



