Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Hat maker questions...

Posts

Hat maker questions...

#1

Steven Antonucci

Hat maker questions...

steven antonucci

Anyone here make turned hats?

I've been screwing around a bit trying to make one, and I just wondered how thick you aim for and why?

In the past, I've gone 60/1000" or so, and they bend easily, but tend to be fragile. I was messing around at 100/1000" and they don't bend as easily, but are much more sturdy without being too heavy. Is there an optimal balance?

Lastly, has anyone looked at steam bending the brims? I spent some time with Hosaluk at a workshop, and he uses a microwave and a wet towel on ladles... I think it should work?

Steve

Re: Hat maker questions...

#2

Re: Hat maker questions...

Dale Miner

I shoot for 3/32 or about .075" and that seems to be a good balance between bending and fragility.

Re: Hat maker questions...

#3

Dennis in Southern Oregon

Re: Hat maker questions...

Dennis in Southern Oregon

Steven, your best advice probably would come from Johannes Michelsen, who I would guess has turned thousands of them by now. He has a how-to-do-it article on the web, which I cannot find right now on a quick search. I have turned eight successful wearable hats and several duds that either broke during the shaping phase or did not take a desirable shape. Based on this limited experience, I would recommend about 3/32" (0.094") for the brim thickness. Most of my failures have come from trying to force thicker (e.g. 1/8") wood to bend in the press. The problem with going much thinner than 3/32 is the increased danger of random variations of cutting depth taking you into negative territory. I have no experience with steam bending of a complex shape like a hat, but my guess is that unless you could build a mold to constrain the bending of the brim, the brim would simply fold along the weakest axis when you apply bending pressure. This conjecture is based on my limited experience with steam bending in which the steamed wood seemed to loose elasticity and behave more like plastic.

Here is a paper by Larry Hancock that I found very useful when I started to turn hats.

http://www.turnedtreasures.com/project.html/hat.html

Dennis

Re: Hat maker questions...

#4

Steven Antonucci

A couple of good tips in there!

steven antonucci

I will have to try some of the things he mentioned. I like the long cone, but I may break down and make a light chuck with LEDs anyway. My biggest issue is getting them bent. I manage the turning part almost EXACTLY the same way Larry does.

Steve

Re: Hat maker questions...

#5

Re: Hat maker questions...

Craig Daymon

Converted for Steve, that would be 75/1000".

BTW, 100/1000" = 1/10" and 60/1000" = 6/100". (I know, sounds less impressive than saying you are turning down to 1000ths of an inch, but based on the values you gave, you're not.)

Sorry, math major. Gotta use it somewhere.

Re: Hat maker questions...

#6

Re: Hat maker questions...

Dale Miner

Yes, .075” is 75/1000” but I stuffed the math when doing a quick in my head calculation.

3/32” is closer to .094” or 94/1000”.

I don't measure with a micrometer though, just eyeball the gap between the caliper jaws.