Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Tung Oil Problem

Posts

Tung Oil Problem

#1

Tung Oil Problem

Bruce Smith

I have been using Lee Valley pure Tung Oil for the last twelve years or so, but the finish that I'm

obtaining recently is not very pleasing. The finish seems to be going blotchy as if it were being

absorbed in the wood more in some places than others on both the inside and outside of the bowl.

The wood in question is of different varieties and I have not changed the way I apply it. Some of

the patches are large and cover an area two or three inches and others are smaller. Does anyone

know if Pure Tung Oil has a shelf life. I know Russ used to say if the oil was thick and or the top of

the lid was all gummed up, then get rid of it but I don't remember him saying why. The oil in the tin

that I was using did not show any of these signs as I always exhaust the air space in the tin with

bloxygen or another inert gas before placing the cap back on. Has anyone ever ran into this trouble

or have any ideas on what is causing my problem?

Re: Tung Oil Problem

#2

Re: Tung Oil Problem

Don Stephan

The first coat or two of any oil finish - tung. blo, danish oil - I expect to go on "blotchy" as some areas absorb the finish more than other areas. Seldom do I see the first coat not show wetter and drier areas a minute after the oil is wiped on.

Re: Tung Oil Problem

#3

Re: Tung Oil Problem

Bill Jacksonville, NC

Some species more prone to give you that Blotchy appearance than others so do not think Tung oil the problem. Reaction wood (wood from damaged part of tree, or bent growth) often give you blotchy spots. You can find several workarounds on line or continue finishing what you have.

Re: Tung Oil Problem

#4

Mike Stafford

Re: Tung Oil Problem

Mike Stafford

I have experienced that problem and because of it I quit using tung oil. However the blotchiness can be reduced if you first apply a sanding sealer compatible with the tung oil. The sanding sealer will be absorbed in the same areas where the tung oil tends to be absorbed and the problem will be reduced or eliminated. It will even out the finish quite nicely.

It is just one more step that I decided I didn't want to have to do.