Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

OT - Compressor Question

Posts

OT - Compressor Question

#1

OT - Compressor Question

Charlie Anderson

My compressor is small but according to the gauges has 100 # pressure. Why can't it inflate a truck tire?

Re: OT - Compressor Question

#2

2 issues

Mark Mandell - Gone Round In New Jersey

1) If the tire is tubeless and the rim is not in contact with the rim all the way around neither your or any other compressor will inflate it. Take a band clamp, run it round the tread surface, tighten it up as best you can, retry tor air.

2) be patient. It's volume of air, not what the pressure gauge reads, that inflates the tire. Once you have the rim sealed to the bead on the tire, your small pump will inflate it; just takes longer than at the tire store.

Re: OT - Compressor Question

#3

Re: 2 issues

Charlie Anderson

This is an already inflated tire. I'm trying to get it from 28 psi to 35 psi. When I connect it to the tire, nothing happens. (I already had the compressor pressure up to where it had shut itself off.)

The reason I wanted to use it is my boat trailer tires are very low but decided I'd test it in the garage before heading to the boatyard.

Re: OT - Compressor Question

#4

Re: 2 more issues

Mark Mandell - Gone Round In New Jersey

Either your regulator valve is shut off (no air going down the hose) or your air chuck is blocked.

Re: OT - Compressor Question

#5

Steven Antonucci

Try pushing the valve stem

steven antonucci

Sometimes, they seize. I always had issues with bike tires, so I always pushed them in first to let some air out and unfreeze the valve.

Re: OT - Compressor Question

#6

Operator Error

Charlie Anderson

So I decided to try again, but still no luck. I was looking at the compressor and wondered what the TWO gauges were. I'd been reading the tank pressure, ignoring the other gauge. As I'm sure everyone knows, it was the output pressure. So I twisted the knob next to it and, voila, the needle moved up. Set it to 80 psi and tested it on the truck. And of course, it works just fine.

Thanks for the help.

Re: OT - Compressor Question

#7

How unusual 


Re: OT - Compressor Question

#8

Ellis Walentine

PEBKAC

Ellis Walentine

Computer geeks have a term for an analogous situation: "PEBKAC -- Problem exists between keyboard and chair." Glad you figured it out. :)

DAMHIKPEBKAC

Re: OT - Compressor Question

#9

Re: Operator Error

phillip medghalchi

Just imagine if you did all the other solutions. :D