Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Indexing holes on 3520b

Posts

Indexing holes on 3520b

#1

Indexing holes on 3520b

Mark ravensdale

Just been wondering about the indexing holes on the 3520b, if dust/wood chips/crud get into these holes will it do any harm to the machine, will crap get into the bearings or hurt the spindle???

Jet/Powermatic sell the lathe with the holes open so one would think that there would be no danger/problem but thought I would ask you guys out there, anyone had any problems because of these open holes??? If so I will look for some small blanking grommets that fit the holes.

Thank you !!!

Re: Indexing holes on 3520b

#2

Re: Indexing holes on 3520b

John Veerkamp

Never had a problem in 4 years of use.

Re: Indexing holes on 3520b

#3

Re: Indexing holes on 3520b

RCH

After 5+ years of using my Jet 1642, I finally decided to try using the index function. Like the Powermatic, the holes have been open to whatever since I have bought the lathe, and I never did anything to or with them. No problem, and I am not the tidiest of turners.

Re: Indexing holes on 3520b

#4

Re: Indexing holes on 3520b

Mark ravensdale

Many thanks guys!!!

That's what I thought, if jet/powermatic sell there lathes with these holes open then surely there would not be a problem with wood chips/shavings getting in and becoming a problem, but it's always worth asking you guy who have actually been using the machine for some time.

Again, MANY THANKS!!!

Re: Indexing holes on 3520b

#5

Don Leydens

Re: Indexing holes on 3520b

Don Leydens

No problem here either, Mark.

Re: Indexing holes on 3520b

#6

Brad Vietje

Re: Indexing holes on 3520b

Brad Vietje

Pas du problem depuis sis ans, Mark...

I have heard that one possible potential problem is not remembering to back out the indexing screw before the next motorized operation, though (er, um,... damhikt... I must have heard it mentioned at a meeting or something... ;~)

Safe spinning,

Brad Vietje

PM3520-B

Newbury, VT

Re: Indexing holes on 3520b

#7

Re: Indexing holes on 3520b

John Lucas

Brad I don't have a 3520B but the 3520A will not start if something is blocking the spindle. I have an index wheel from IronfireLLC and if I accidentally turn on the lathe before removing the pin from the wheel it won't come on. It senses that something is holding the spindle and will stop.

That is not true of the Jet1642 that I was demoing on the other day. I was using magnetic block to hold my indexing pin and turned the lathe on and it threw the block. Fortunately it just sort of flopped over the lathe and fell on the floor.