Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Start With A Blank Sheet Of Paper

Posts

Start With A Blank Sheet Of Paper

#1

Start With A Blank Sheet Of Paper

charlie belden

If you were an experienced wood carver,never exposed to a lathe, turning gouges and chisels or existing turning technique - but very familiar with how the direction of the grain dictates how it can be carved without tear out or splitting

and

you were given a cross section of a bowl profile, or spindle profile to carve into the flat face of a board

and

told that the carving tool could be rotated on three axes and move in and out on one axis and the wood would be rotating about a single axis that would be oriented in any location of the piece of wood

and

you knew enough physics to understand the forces involved

and then

asked to come up with a cutting tool, or perhaps two or three cutting tools that would do the job (a real constraint for a wood carver who has a tool roll or two of carving tools - sweeps,veiners, swan necks, etc.)

what would you come up with?

Would it look pretty much like an existing bowl gouge - or something significantly different?

Conversely, were a carver to be given a fingernail ground spindle gouge, what carving cuts could he/she use this tool for and which carvers tools would it substitute for?

Lee Valley / Veritas has a history of studying the function a hand plane, then, starting with a blank sheet of paper and a list of well thought out criteria for what the tool is to do, designs and then makes a tool to do the specified job - with ergonomics as a key design criteria. They aren't constrained by It Has To Look Like This (because that's what the existing Tried and True tool Has ALWAYS Looked)

What might they come up with for the basic turning tools we use?

What would YOU change?

Here are some things I'd like to see

1. A more triangular handle for better leverage

and

that would keep the tool from rolling around when

placed on a flat surface

2. A reference mark on the handle to give you a visual

clue as to how the cutting edge is oriented when you

can't see it

3. rectangular cross section tools - like a flat skew - have

the corners rounded/ "eased" slightly to be easier on

my hands - and tool rest.

Re: Start With A Blank Sheet Of Paper

#2

You just described Johannes Michelson's tool  *LINK*


http://hannestool.com/