Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Omeg stuby 1000 problem

Posts

Omeg stuby 1000 problem

#1

Omeg stuby 1000 problem

Terry Scott

My Vacuum pump set up has stopped working as the fitting on the shaft is not sealing I beleive there is an o ring and a plastic flange that when the Vacuum is turned on pulls up against the bearing.

Any ideas how I can either fix it or adapt a way to make it work .Not having a vacuum pump is a pain in the ask your mother in law to breakfast.

I have a normal Tellis set up on another lathe but that only holds 1/4 of what my big vacuum pump does. Or did

Can I put a tube down the hole and do a hand wheel set up or is the hole that is in the shaft making this a no go.

Please make it a simple repair as I am not that Mechanically minded

Thanks in advance

Re: Omeg stuby 1000 problem

#2

Re: Omeg stuby 1000 problem  *LINK*

walta

Have you contacted?

Bill Rubenstein at bill@stubbylatheusa.com

Are you a member of the Yahoo stubby group?

It seems the factory ports have been a problem.

I think Bill has a set up just for your lathe.

Walta


Stubby Lathe USA

Re: Omeg stuby 1000 problem

#3

Re: Omeg stuby 1000 problem

Mark Mandell - Gone Round In New Jersey

Hi Terry,

The 1000 headstock is exactly the same as that on the 750 (only the base is different) so the "fix" is the same.

The vacuum on my 1000 lost seal when the sealing washer on the spindle got misplaced. Try this:

1. Moisten a cotton swab with petrolium jelly (vasoline) and use it to clean the flange at the very back of the spindle inside the headstock. You will also see the plastic washer seal there. Clean by holding the swab in place and rotating the spindle by hand.

2. Wil another clean swab, apply a thin coating of vasoline to the surface.

3. Now, using a spatula or thin shim, push the plastic washer and "O" ring back against that rear flange will rotating the spindle, again by hand.

The Vasoline will help the washer make a good seal on the vacuum flange.

Start your vacuum pump and repeat step 3.

If your washer has been damage such that it won't seal, your option is to mount a through-the-spindle vacuum adapter. As mentioned, Bill Rubinstein has put together a rig with a flexible tube to feed through the spindle

Re: Omeg stuby 1000 problem

#4

Re: Omeg stuby 1000 problem thanks

Terry Scott

Thanks guys Ive contacted Bill and he is sending the adapter set next week '

At $86 plus post il be up and running pronto

Worth twice that so I can again have a pump working

Cheers

Re: Omeg stuby 1000 problem

#5

Steve Kubien

Re: Omeg stuby 1000 problem thanks

Steve Kubien

Bill is a top-notch guy. He was a huge help to me when I bought my second-hand S-750. Got my vaccum and adapter from him as well.