Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Bottom measurer. . er

Posts

Bottom measurer. . er

#1

Bottom measurer. . er

Darryl

On occasion I find it nice to know where the bottom of a natural edge bowl (or any bowl for that matter) is. I made up a simple and cheeep thingy to give me the info. My lathe has a 16" swing so the lengths of the items are driven by that. I cut a piece of wood about 16.5" in length. drilled a hole in the middle. then I took some rather stiff wire and bent it into a flat "U" the top of the "U" is 8 1/4" long. The two legs are identical in length and about 10" long. The 10 " is because I rarely have a bowl that deep. I slipped a piece of gum erase on one leg to serve as a friction mechanism. Stick that leg through the hole in the wooden piece and hold the thing so the wood touches both sides of the bowl wings. The one leg goes to the bottom of the bowl the other shows me exactly where the one leg has bottomed out on the outside. The outside leg can be swiveled until it touches the outside of the bowl. I make a mark on the bowl on the outside leg and remove the "Rube Goldberg" affair. (for those who do not know Rube no explanation is possible for those that do it shows your age.: )

When I am reverse turning with my vacuum chuck first I measure from the front of the chuck face and make a pencil mark on my head stock. After affixing my bowl I just put the square at the mark and the end of the ruler shows me where the bottom of the bowl is. that keeps my from making funnels or leaky bowls.

I'm certain there are many other ways to do the same thing suggestions???

Re: Bottom measurer. . er

#2

Ellis Walentine

Great suggestion

Ellis Walentine

A diagram would help a lot, but I get the gist of your gauge. Let's see how others do it.

Ellis

Re: Bottom measurer. . er

#3

Re: Great suggestion

Darryl

I tried to find a way to include a sketch. Read the FAQ but did not find the " little blue box" and any way to attach a file unless it was a photo on the internet with its url.

Re: Bottom measurer. . er

#4

Re: Great suggestion

g clarke

a photo would also be nice. sounds like a neat "thingy"

Re: Bottom measurer. . er

#5

Re: Bottom measurer. . er

Jeff Smith

Not sure I'm picturing the whole procedure completely, but it sounds helpful. Reed Gray has a very simple method to determine where your bottom is, I've found it a pretty simple method. Just need to find that stick in the pile of shavings. Here's a link to his method

http://www.youtube.com/watch?v=0Ov5m50NXJ8

Re: Bottom measurer. . er

#6

Re: Bottom measurer. . er

Darryl

Yes robo hippe's is much more exact and exacting. That is why I started trying to figure out a simpler method. I'd like to include a diagram but can't figure out how. It is simple though just a piece of wood across the bowl wings with a hole in the center. The wire has two legs separated across the top by the radius of your swing. One leg goes into the hole to the bottom of the bowl. The other leg is the outside measuring piece.