Turning question - Scales of Justice
Craig Daymon
I have a friend who is a lawyer. (Don't hold it against him, he's a really good guy.) He just had one of those milestone birthdays and I turned a hollowform to send him. I wanted to put a lid with a finial on it and was trying to think of a way to turn a set of the "scales of justice" as the finial.
The hollowform is maybe 6" high and 4" in diameter, so I'm talking a relatively small set of scales and no blind lady justice involved, just the scales.
Should I forget about actually making them rock on a pivot point? Should I make the trays solid cones with round bottom and just paint them to appear to be suspended by 3 chains or actually use 3 short wires and tiny turned bowls on the ends? Should it disassemble? It will have to be shipped, but the hollowform is pretty thin skinned already, so it will be a delicate packing either way.
I'd also like to do as much as possible on the lathe, so I'm considering sandwiching the board for the arms of the scale between some scrap so I can turn an arch in the board and maybe a conical pivot point in the center.
Obviously, I'm still trying to flush out the idea and I'm open to any suggestions or considerations I need to keep in mind.
Thanks in advance,
Craig



