Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Nova dvrxp went bang!!!

Posts

Re: Nova dvrxp went bang!!!

#26

Re: Nova dvrxp went bang!!!

Ralph Lindberg

Probably not

Failures do happen (with all electronic lathes, including the PM/Jet's), but I know school/pro lathes that have run many thousands of hours.

Our (personal) DVR-XP has probably 10x the hours then the DVR-XP the local club owns, but I have had to "fix" (swap boards) on the club lathe twice and had no failures on ours.

Re: Nova dvrxp went bang!!!

#27

Failure mode and repair

Ralph Lindberg

Mark

I've ended up working on, well, three DVRs so far (but not ours).

My guess, based on your comments is the main-board fried. I don't think the motor died (I have yet to hear or see a DVR motor fail)

Now that is not the most expensive part, in the US it's about a $400 part. (650 pounds maybe).

But getting it out is a two man job, as you have to pull the head.

Personally I would NOT part the lathe out, I would either fix it, or sell it as a "unit" to someone that is willing to spend the time and effort fixing it.

Re: Nova dvrxp went bang!!!

#28

Re: Failure mode and repair

Mark ravensdale

Thanks Ralph, thinks I may put a couple of adverts in my local turning shops (here in the UK), and see if anyone is interested in buying it as a fixer-upper, I agree with you that it's probably the main circuit board that's fried, I heard a loud pop (not bang) and then smelt that fried component smell, I pluged it back in to the electricity supply again after a couple of minutes (stupid idea I know!) and smoke started to come out of the little holes round the hand wheel so unplugged it immediately, it's in pieces now (but not the head-stock) so I could get it out of my little workshop, to make way for a new Jet 3520b that I will receive early next week (Monday or Tuesday I hope!!!), was gutted when it broke, I really loved turning on it and I got on well with its controls (which some people don't like) and its combination of small size with 2hp motor worked/sat really well in my small workshop, if it hadn't died I would not have given a thought to replacing it with something different, but having said that, I am REALLY looking forward to putting the 3520b through it paces, I had heard so many glowing/great reports abt it it seemed like the obvious choice for me, the only thing that now worries me abt the 3520b is assembling it!!! (somewhat heavier than the dvrxp, and once I get my ballast box on it will weigh in at well over 1000lbs, sure hope I don't need to move it anytime in the near future (ouch!!!))