Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Problem with thread chasing

Posts

Problem with thread chasing

#1

Problem with thread chasing

John Lucas

When I was doing the demo in Arizona I had a problem with the thread going on a sort of tilt. I think some how half a revolution around it skipped a tooth so the thread jumped. At this point it's impossible to correct it. I've had this happen twice in the last dozen ornaments. Anybody got any ideas. Maybe I'm pushing to hard at the start of the thread. Once it starts I try really hard to let it pull the cutter.

I have also had a problem one time with the thread getting a second start so I have a double thread. It threads on perfectly but will be 180 degrees out when aligning the grain. Screw it off and start again the the grain will align perfectly. I think this is simply a problem of the thread starting itself in 2 different places as you first start the thread since your going in and out of the cut. My rhythm must be off but then if you saw me dance you wouldn't even question that. :)


Re: Problem with thread chasing

#2

Re: Problem with thread chasing

jake Niedling

Hey John, I thought I was the only person that could do that. Once again I find out that I am not special, but at least in this case in good company. The name I heard for this was called a " Drunken Thread " and yes it does usually jump a thread. It starts very early in the process when you are usually striking the treads and your rhythm is out of whack. But once it starts, the thread chaser will follow and keep making it deeper. There is no correcting that I know of once you have it, other than starting over. :D

Re: Problem with thread chasing

#3

Re: Problem with thread chasing

allan joicey

I have had some success by reversing the lathe and using the chaser on top of the work piece. Starting from the inside and traversing left to right sometimes cleans up the damaged section. Of course the support of the tool rest is not available

Re: Problem with thread chasing

#4

Mike Peace

Re: Problem with thread chasing

Mike Peace

What speed were you threading at? Drunken threads are usually caused by too slow a speed. 330 RPM works for me with 16 tpi chasers. Once you get the thread started the full length, you can slow the lathe down some.

Re: Problem with thread chasing

#5

Re: Problem with thread chasing

John Lucas

Interesting. I was chasing a little slower than normal, probably 250 or so. I'll have time to play some more in a another week. I'll play. I can see where slow speeds might make it easier to get a double thread. Still now sure how I get the Drunken threads.