Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Jet Mini Bearing Replacement

Posts

Jet Mini Bearing Replacement

#1

Jet Mini Bearing Replacement

Joe Pack

I didn't realize how rough and noisy the headstock in my Jet mini was until I attended a local club meeting and heard the Jet mini the club owned. The growling in mine just sort of crept up on me, I guess.

How difficult is it to change the bearings in the Jet mini headstock? Should I contact Jet for the OEM bearings, or head to a local bearing shop?

Re: Jet Mini Bearing Replacement

#2

Re: Jet Mini Bearing Replacement *LINK*

Craig Daymon

It's not too hard. I did it several years back now. (Might be time I did it again.) I think there is a clip from the message board on the WoodCentral "Articles" page somewhere that talks about it and gives the bearings I used when I did it. (I put in a higher grade of bearings than the stock ones when I replaced them.)

I searched the archive and found the response thread for my post about this. The link is below.

A great source for information on the difference between the bearings (or almost any industrial supply) is McMaster-Carr ( http://www.mcmaster.com ). Look up bearings and you can get info on differences in the types. (Double sealed, tapered, etc.)

-Craig


Previous thread about JET bearings.

Re: Jet Mini Bearing Replacement

#3

very easy

Dick Coers

It's a very simple procedure. I went to a local bearing shop, but wish I would have gotten a better class of bearing. The ones I got were really cheap, but not as quiet as I had hoped. Sorry, can't provide any part numbers or bearing info, but it's all over the web.

Re: Jet Mini Bearing Replacement

#4

Re: Jet Mini Bearing Replacement

Joe Pack

Great information, Craig. Thanks.

Re: Jet Mini Bearing Replacement

#5

Re: very easy

Joe Pack

Thanks Dick. I appreciate the reply.

Re: Jet Mini Bearing Replacement

#6

Re: Jet Mini Bearing Replacement

Jeff Brockett

I replaced both bearings and the belt in my Jet mini lathe in under an hour.