Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Refridgerator Kiln

Posts

Refridgerator Kiln

#1

Refridgerator Kiln

Roy

I read a bunch of information regarding building a refrigerator kiln, but with limited space, I built one out of a large cooler. I drilled holes on the top and bottom, installed shelves, used a 40 watt bulb and small fan to move the air around efficiently. I loaded it up with 8 rough turned bowls and within a week the moisture went from 30+ to under 17%. But I lost 2 of the bowls due to cracking. I just received the thermometer/hydrometer I ordered and found the temperature to be at 87 degrees. I'm thinking this is way to hot to start the process.

Does anyone have advise on the what the temperatures ranges to use as the wood dries? The information I found only discussed starting with a 40 watt bulb and then using stronger wattage bulbs as the bowls dry but that was in a full sized refrigerator.

Thanks in advance any help you can provide.

Re: Refridgerator Kiln

#2

Steve Kubien

Re: Refridgerator Kiln

Steve Kubien

I can't speak of temps (I don't keep track of it with my fridge kiln) but I would suggest popping the lid open for a bit everyday.

Re: Refridgerator Kiln

#3

Re: Install a light dimmer

Doc Green

A small light dimmer from a big box store will allow you to cut the wattage back to whatever level you wish. Then you can turn it up as the drying progresses along.

Re: Refridgerator Kiln

#4

Re: Install a light dimmer

bill Crommett

The important thing is to let the moisture out very slowly so the wood is all at the same RH.

Re: Refridgerator Kiln

#5

Re: Refridgerator Kiln *LINK*

Mike Brazeau

Roy - I would recommed that you start out the process at room temperature and let the humidity build up in the kiln and then start introducing some heat after a few days. If in a cold shop, use some heat from the start but keep it low so the temperature is what normal room temp would be. At the link, my observations are in an article I wrote a couple of years ago. Many references use 95F as a drying temperature. When the wood is near dry, I have gone as high as over 40C which is well over 100F. A Taylor Humidistat/Thermometer is handy to have and keep notes as the batch progresses. Every few days, I take a few pieces out and weigh them and record weights, usually just writing on the wood itself with a ballpoint pen. It doesn't take long to get a good feel for the process.


Simple kiln

Re: Refridgerator Kiln

#6

Thanks everyone

Roy

Thanks everyone for your help and suggestions. I'll keep you posted on the results of my second attempt.

Re: Refridgerator Kiln

#7

Re: Install a light dimmer

Devon Palmer

+1 to the dimmer and 40W bulb

I use an upright freezer to dry smaller wet items and finish dry larger bowls. I generally wax/bag for the first 3 months while the free-water escapes and the moisture is around 20%. I'll then load it with as much wood as it will hold and start the temp out 10 degrees higher than ambient. There's small 3" hole cut out of the top that I'll keep 90% covered. Each week I raise the temp 10 degrees. 5-6 weeks later and the contents are down to EMC.