Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

This was posted on the flat side but I want one. *LINK*

Posts

This was posted on the flat side but I want one. *LINK*

#1

This was posted on the flat side but I want one.  *LINK*


http://vimeo.com/58018004

Re: This was posted on the flat side but I want one. *LINK*

#2

Re: This was posted on the flat side but I want on

Jorge

Neat, the guys that make timberframes have had similar for a long while, it makes the mortises and tenons...

Re: This was posted on the flat side but I want one. *LINK*

#3

Re: This was posted on the flat side but I want on

Bruce Markwardt

Pretty amazing!

Re: This was posted on the flat side but I want one. *LINK*

#4

Liam O'Neill should have one of those!

Don Orr

Imagine what he could do with one of those!

Re: This was posted on the flat side but I want one. *LINK*

#5

Re: This was posted on the flat side but I want on

robo hippy

I will admit to drooling a bit. I have been pondering for years now how to make a chain saw type chop saw that would be simple, and I could make straight cuts through the center of a bowl blank log section. This one is a bit beyond me. Even if I did make one, liability would probably kill it....

robo hippy

Re: This was posted on the flat side but I want one. *LINK*

#6

Re: Liam O'Neill should have one of those!

Craig Daymon

That's the guy that cores those massive bowls using a chain saw plunge cut, right?

I have the book that shows him doing that. Scary. Very impressive bowls, that large and thin.

Re: This was posted on the flat side but I want one. *LINK*

#7

Re: This was posted on the flat side but I want on

bill Crommett

John: That will have to wait until you get your 3000 sq. ft. shop.

Re: This was posted on the flat side but I want one. *LINK*

#9

"Woodturning Masterclass" Anthony Bryant

Craig Daymon

No, the guy I'm thinking of is Anthony Bryant. He is the first turner featured in the book, "Woodturning Masterclass" by Tony Boase.

In it, there is a pic of him coring about a 24" diameter bowl blank using a chain saw. This is before it goes on the lathe. Then he uses gouges with VERY extreme, long grinds.

He does some of a similar shape to Liam's, but I can't say if he uses the chain saw to rough it out.

Thanks for posting the link to Liam's demo. Very interesting.

-Craig

P.S. A pretty decent book which includes some of the ways the featured turners create their forms. 13 different turners.