Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Epoxy overrun

Posts

Epoxy overrun

#1

Epoxy overrun

Ed Larson

I just finished using epoxy to glue the spindle into the top and bottom of a wig stand. Of course I used too much epoxy and had to wipe it from the finished (deft lacquer) pieces. I used a paper towel and did a reasonable job of removing it. How do other handle this?? Is there a solvent that will remove the epoxy and not the lacquer??

Re: Epoxy overrun

#2

Dennis in Southern Oregon

Re: Epoxy overrun

Dennis in Southern Oregon

Ed, I generally dry fit the joint and then wrap masking tape around the exposed parts of the joint before applying glue. If I remember correctly unset epoxy can be cleaned off with mineral spirits or turpentine

Dennis

Re: Epoxy overrun

#3

Re: Epoxy overrun

Don Stephan

Epoxy sounds like overkill for these joints unless they were loose. I use hide glue, which cleans up well with warm water.

Re: Epoxy overrun

#4

Re: Epoxy overrun

Chuck Engstrom

White vinegar is a solvent for epoxy and I don't think it would attack the lacquer. It's not as vigorous as acetone and such but it will help. It's pretty good for tool and hand clean-up without being nearly as harmful to your body.

Best -- Chuck

Re: Epoxy overrun

#5

White vinegar!

Jorge

Ed

White vinegar does a good job and it is easier on the lungs (and the pocket) than acetone. A trick from my boatyard days.

Always keep, a bottle of vinegar and paper towels...

Re: Epoxy overrun

#6

Re: White vinegar!

Craig Daymon

Another vote for white vinegar. Works great...as long as it hasn't set yet. At that point I reach for a razor blade and scrape real carefully.

Re: Epoxy overrun

#7

Re: Epoxy overrun

John Lucas

I use Alcohol while the epoxy is still wet. I have done this for hears on my mirrors. I usually have at least one coat of lacquer on everything before I glue them up. It hasn't hurt the lacquer yet although it can dull it slightly. I'm usually applying more coats afterwords so it's not a problem.

Re: Epoxy overrun

#8

Re: White vinegar!

Joe Herrmann

Another vote for the white vinegar. I took a hands-on workshop with Marilyn Campbell and we used vinegar to clean up our mixing boards, etc. Never would have believed it if I hadn't seen it!

Re: Epoxy overrun

#9

Re: White vinegar!

John Lucas

White vinegar also works very well for softening PVA glues. It will actually get dried glue out of your clothes. I haven't tried it for epoxy, but Marylin knows her stuff.

Re: Epoxy overrun

#10

Waterless hand-cleaner.

Keith Newton

While the vinegar and alcohol may be better options, if you don't have the others close at hand.

If it is still wet,you can massage it, to mix them into the emulsion.

But, I usually like to use masking tape, then a finger to squeegee it in, them peel it while wet. Don't let it cure, with the tape on.

But if you wait until it has cured to a leather stage of toughness, a thumbnail, or other dull tools like putty knife can push it off a smooth surface.