Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Seg/Stave Pic

Posts

Seg/Stave Pic

#1

jim miles

Seg/Stave  Pic

jim miles


I haven't been able to post pictures in a while, so i am catching up on some older work. Segmented & Staved, Walnut, about 24' tall

Re: Seg/Stave Pic

#2

Mike Stafford

Re: Seg/Stave  Pic

Mike Stafford

Very nice, Jim!

Re: Seg/Stave Pic

#3

Harry Robinette

Re: Seg/Stave  Pic

Harry Robinette

Jim

Very nice piece, but the M&M's will fall out.

Re: Seg/Stave Pic

#4

Re: Seg/Stave  Pic

H. Phillip Medghalchi

Jom that's ver beautiful. Did youturn it hollowed on the lathe? Or, did you crved it out after the turning?

Re: Seg/Stave Pic

#5

Jim Barbour

Re: Seg/Stave  Pic

Jim Barbour

Nice work. Puts me in mind of a bollard.

Re: Seg/Stave Pic

#6

Re: Seg/Stave  Pic

Jim Breeden

Excellent !

Re: Seg/Stave Pic

#7

Dale Jablonski

Re: Seg/Stave  Pic

Dale Jablonski

Beautiful job!

Re: Seg/Stave Pic

#8

jim miles

Re: Seg/Stave  Pic

jim miles

The upright pieces ( staves ) are band sawn to rough shape , it is assembled and then turned inside & out on the lathe.

Re: Seg/Stave Pic

#9

Ellis Walentine

Whew! 24" is a big vessel!

Ellis Walentine

I assume this stack was fixed to a faceplate for turning, but how do you finish-turn the bottom?

Ellis

Re: Seg/Stave Pic

#10

jim miles

Re: Whew! 24" is a big vessel!

jim miles

Yes, it is done with a faceplate & waste block. I part it off the waste block partially, and finish the rest of the bottom off the lathe.