Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Bradford pear Lidded form

Posts

Bradford pear Lidded form

#1

Bradford pear Lidded form

Roger Chandler

Bradford pear Lidded form

The ambrosia maple/ redwood form was taken back to the shop today.......after searching through my stash of small pieces of wood, I found a piece of Bradford pear that looked like it had potential.......I put the curly redwood lid up against the blank and it looked promising.......

I proceeded to turn a form similar to the ambrosia form, only more length and I like a foot on a vessel so I decided to make a dome shaped foot to replicate the dome shape on the lid. When I got it done, I put the curly redwood lid on it.........not much better than it was on the ambrosia........drop back and punt.

So I cut another piece of that pear, and decided to turn a lid of the same kind.....off the same blank! Well, with the sapwood and swirling grain, this one did not grain match as well as I wanted it to, even though it was from the same larger piece, and I tried to orient the grain the same.

This one is 7.25" high at the knob and 5 inches wide. Comments always welcome!

Re: Bradford pear Lidded form

#2

Steven Antonucci

Even without the gain match, 100% improvement.


Re: Bradford pear Lidded form

#3

Re: Even without the gain match, 100% improvement.

Roger Chandler

I think that the necessity of turning a tenon for the chuck is what caused the lines in the grain not to line up exactly.....that would cause a gap in the figure.