Winged Cherry Box
Bob Moffett
Joe Herman, editor of Wood Turning Design magazine, demonstrated winged bowls at our club a while back. I enjoyed his demo very much and decided to try and incorporate his design into a box. The box is 12 ¾” long, 4/14” wide, 1 5/8” high with a 4” finial. The box is made of cherry and the finial is made of ebony. The wings are turned to 1/8” thick and are about 4 ½” wider on either side of the box, the box portion being 4” wide. These boxes are best turned at a high speed so, they are not for the timid of heart. They sound like an airplane propeller when you are turning them. It can be quite unnerving! I made the finial thicker and heavier than I normally would because, being a box, the finial may be used to lift the lid and therefore I didn’t want it to be as delicate as normal. Texturing on the top and bottom and lid of the box was done with both a Waggoner Tool and the small Sorby spiraling tool. I will be teaching a box class at John Campbell this summer and may do one of these for an evening demo. The finish is Minwax Antique Oil. C & C appreciated.



